Convert mil to nautical mile (international) Online | Free Length Converter

Mil

A mil is a unit of length commonly used in engineering and manufacturing to measure very small distances, especially thicknesses. It is equal to one-thousandth of an inch (0.001 inch), which is approximately 0.0254 millimeters.

The mil is widely used in industries like plastic film, coatings, wire diameter, and mechanical parts, where precise measurements of thin materials are necessary. It should not be confused with the millimeter, which is 0.001 meters or 1,000 microns — much larger than a mil.

Key points:

• 
  

  1 mil = 0.001 inch = 0.0254 mm

  
  
• 
  

  Used mainly for small thicknesses or diameters

  
  
• 
  

  Common in engineering, manufacturing, and material sciences

  
  
• 
  

  Not to be confused with millimeter (mm)

  
  

The mil remains an important unit in technical fields where fine measurement is critical.

Nautical Mile (International)

A nautical mile (international) is a unit of measurement used primarily in maritime and aviation contexts. It is defined as 1,852 meters or 1.852 kilometers, which is approximately 1.1508 statute miles. The nautical mile is based on the Earth's geometry, representing one minute of latitude along any meridian. This makes it particularly useful for navigation, as distances on charts and GPS systems often relate directly to degrees of latitude and longitude. The international nautical mile was officially adopted by the United States in 1954 and is now used worldwide for consistency in global navigation. It is closely linked with the knot, a unit of speed equal to one nautical mile per hour. The standardization of the nautical mile has greatly simplified communication and coordination in international travel, trade, and defense across oceans and airspace. Its use continues to be essential in global navigation systems today.