Foot-Pound per Minute per Square Foot [ft·lb/(min·ft²)]

The unit foot-pound per minute per square foot, written as ft·lb/(min·ft²), measures energy flux density or power per unit area in the Imperial system. One foot-pound (ft·lb) is the energy required to move a force of 1 pound-force over a distance of 1 foot, equivalent to 1 ft·lb ≈ 1.35582 joules. Dividing by time (minutes) and area (ft²) gives the rate of energy transfer per unit area over time.

This unit is commonly used in U.S.-based engineering, building physics, and solar energy studies where energy flux through surfaces is measured. Applications include:

• 
  

  Heat transfer through walls, floors, or roofs

  
  
• 
  

  Solar radiation incident on building surfaces

  
  
• 
  

  Mechanical or thermal energy flux in industrial processes

  
  

Mathematically, the flux is expressed as:

where q is flux in ft·lb/(min·ft²), E is energy in foot-pounds, A is area in ft², and t is time in minutes.

Conversion to SI units:

While modern practice favors W/m², ft·lb/(min·ft²) remains relevant in legacy U.S. building and thermal engineering literature, providing an intuitive measure of energy transfer per square foot per minute.

Btu (IT) per Hour per Square Foot [Btu(IT)/(h·ft²)]

The unit Btu (IT) per hour per square foot, written as Btu(IT)/(h·ft²), measures heat flux density or thermal power per unit area using the International Table British Thermal Unit (1 Btu(IT) = 1055.06 J). It represents the amount of heat energy transferred through 1 square foot of surface every hour.

This unit is widely used in U.S. building construction, insulation, HVAC, and solar energy studies to quantify energy transfer through walls, roofs, or floors. Typical applications include:

• 
  

  Heat loss or gain through building surfaces

  
  
• 
  

  Solar radiation incident on horizontal surfaces

  
  
• 
  

  Design and analysis of heating and cooling systems

  
  

Heat flux is mathematically expressed as:

where q is heat flux in Btu(IT)/(h·ft²), Q is energy in Btu(IT), A is area in ft², and t is time in hours.

Conversion to SI units:

Although modern practice uses W/m², Btu(IT)/(h·ft²) remains prevalent in U.S. building codes, insulation tables, and historical thermal data, offering a convenient measure of energy transfer per square foot per hour.