Foot-Pound per Minute per Square Foot [ft·lb/(min·ft²)]

The unit foot-pound per minute per square foot, written as ft·lb/(min·ft²), measures energy flux density or power per unit area in the Imperial system. One foot-pound (ft·lb) is the energy required to move a force of 1 pound-force over a distance of 1 foot, equivalent to 1 ft·lb ≈ 1.35582 joules. Dividing by time (minutes) and area (ft²) gives the rate of energy transfer per unit area over time.

This unit is commonly used in U.S.-based engineering, building physics, and solar energy studies where energy flux through surfaces is measured. Applications include:

• 
  

  Heat transfer through walls, floors, or roofs

  
  
• 
  

  Solar radiation incident on building surfaces

  
  
• 
  

  Mechanical or thermal energy flux in industrial processes

  
  

Mathematically, the flux is expressed as:

where q is flux in ft·lb/(min·ft²), E is energy in foot-pounds, A is area in ft², and t is time in minutes.

Conversion to SI units:

While modern practice favors W/m², ft·lb/(min·ft²) remains relevant in legacy U.S. building and thermal engineering literature, providing an intuitive measure of energy transfer per square foot per minute.

Calorie (IT) per Second per Square Centimeter [cal(IT)/(s·cm²)]

The unit calorie (IT) per second per square centimeter, written as cal(IT)/(s·cm²), measures heat flux density or power per unit area. It represents the amount of International Table calories (1 cal(IT) = 4.1868 J) transferred through 1 cm² of surface every second.

This unit is often used in laboratory-scale heat transfer experiments, solar energy studies, and radiation measurements, especially when dealing with small surface areas where the calorie is convenient. Applications include:

• 
  

  Measuring solar energy intensity on small surfaces

  
  
• 
  

  Calorimetry experiments on samples

  
  
• 
  

  Laser or focused radiation studies

  
  

The heat flux can be expressed mathematically as:

where q is heat flux in cal(IT)/(s·cm²), Q is energy in calories, A is area in cm², and t is time in seconds.

Conversion to SI units:

While W/m² is the SI standard, cal(IT)/(s·cm²) is convenient for small-area, high-intensity heat measurements in laboratory or historical contexts.