Watt per Square Meter [W/m²]

The unit watt per square meter (W/m²) measures heat flux density or radiant flux, representing the amount of energy transferred per unit area per unit time. One watt equals 1 joule per second, so 1 W/m² corresponds to 1 joule of energy passing through 1 square meter every second.

This unit is widely used in physics, engineering, meteorology, and solar energy studies to quantify energy transfer rates across surfaces. Examples of applications include:

• 
  

  Solar radiation: measuring sunlight incident on a surface

  
  
• 
  

  Heat transfer: quantifying conduction or convection per unit area

  
  
• 
  

  Building energy analysis: evaluating heat gain or loss through walls and roofs

  
  

Mathematically, the heat flux is expressed as:

where q is heat flux in W/m², Q is energy in joules, A is area in square meters, and t is time in seconds.

For example, solar constant at Earth’s surface is approximately 1361 W/m², indicating the power received per square meter from the Sun outside Earth’s atmosphere.

W/m² is the standard SI unit for energy flux density, replacing older units like cal/cm²·s or Btu/ft²·h, and is essential for thermal engineering, climatology, and renewable energy calculations.

Kilocalorie (IT) per Hour per Square Meter [kcal(IT)/(h·m²)]

The unit kilocalorie (IT) per hour per square meter, written as kcal(IT)/(h·m²), measures heat flux density or thermal power per unit area using the International Table kilocalorie (1 kcal(IT) = 4186.8 J). It represents the amount of heat energy transferred through 1 square meter of surface in 1 hour.

This unit is often used in building engineering, HVAC, and solar energy studies to quantify energy transfer through walls, roofs, or solar collectors. Typical applications include:

• 
  

  Heat gain or loss through building surfaces

  
  
• 
  

  Solar energy incident on rooftops or flat surfaces

  
  
• 
  

  Design of heating and cooling systems

  
  

Mathematically, heat flux is expressed as:

where q is heat flux in kcal(IT)/(h·m²), Q is total heat in kilocalories, A is area in m², and t is time in hours.

Conversion to SI units:

Although SI units such as W/m² are now standard, kcal(IT)/(h·m²) remains useful in legacy building and thermal engineering literature, providing an intuitive measure of energy transfer over time in kilocalories.