Kilocalorie (IT) per Hour per Square Foot [kcal(IT)/(h·ft²)]

The unit kilocalorie (IT) per hour per square foot, written as kcal(IT)/(h·ft²), measures heat flux density or thermal power per unit area using the International Table kilocalorie (1 kcal(IT) = 4186.8 J). It represents the amount of heat energy transferred through 1 square foot of surface in 1 hour.

This unit is commonly used in U.S.-based building construction, insulation, and HVAC studies to quantify energy transfer through walls, floors, or roofs. Typical applications include:

• 
  

  Heat loss or gain through building materials

  
  
• 
  

  Solar energy incident on rooftops or horizontal surfaces

  
  
• 
  

  Design and analysis of heating and cooling systems

  
  

Mathematically, heat flux is expressed as:

where q is heat flux in kcal(IT)/(h·ft²), Q is total heat in kilocalories, A is area in ft², and t is time in hours.

Conversion to SI units:

While modern practice uses W/m², kcal(IT)/(h·ft²) remains prevalent in legacy U.S. building and insulation data, offering a convenient way to evaluate thermal energy transfer over a typical hourly timescale.

Foot-Pound per Minute per Square Foot [ft·lb/(min·ft²)]

The unit foot-pound per minute per square foot, written as ft·lb/(min·ft²), measures energy flux density or power per unit area in the Imperial system. One foot-pound (ft·lb) is the energy required to move a force of 1 pound-force over a distance of 1 foot, equivalent to 1 ft·lb ≈ 1.35582 joules. Dividing by time (minutes) and area (ft²) gives the rate of energy transfer per unit area over time.

This unit is commonly used in U.S.-based engineering, building physics, and solar energy studies where energy flux through surfaces is measured. Applications include:

• 
  

  Heat transfer through walls, floors, or roofs

  
  
• 
  

  Solar radiation incident on building surfaces

  
  
• 
  

  Mechanical or thermal energy flux in industrial processes

  
  

Mathematically, the flux is expressed as:

where q is flux in ft·lb/(min·ft²), E is energy in foot-pounds, A is area in ft², and t is time in minutes.

Conversion to SI units:

While modern practice favors W/m², ft·lb/(min·ft²) remains relevant in legacy U.S. building and thermal engineering literature, providing an intuitive measure of energy transfer per square foot per minute.